Simpson R3 Manuel d'utilisateur

Installation Manual The products and parts shown herein are to be installed and used adjusted in accordance with these instructions. Any deviation

2 Attaching the Helmet D-Ring The R3 Head and Neck Restraint comes with all of the parts to attach the D-rings to the helmet. Supplied are: (2) 10-3

3 6) Drill the helmet using a 3/16” drill at the point marked in step 5. 7) Clean the hole in the helmet as much as possible. Put a medium stre

4 The R3 is placed on back of the occupant between the seat and the driver’s back and shoulders. Because of this, it is recommended to contour the b

5 The shoulders of the restraint should sit under the shoulder belts between the seat back and the oc-cupant. The shoulder belts of the car should

6 Helmet Tether / In Car Adjustment The Helmet Tethers need to be adjusted with the driver seated and buckled into the vehicle. Loosen the helmet te